LAB 1.001
I have made a LAB using GNS3 and PIX 8.02
My setup is below:
LAN ---- ETHERNET ---- PIX ------------- OUTSIDE NETWORK
and here's my config, incase I need it.
pixfirewall# sh run
: Saved
:
PIX Version 8.0(2)
!
hostname pixfirewall
enable password 8Ry2YjIyt7RRXU24 encrypted
names
!
interface Ethernet0
nameif inside
security-level 100
ip address 192.168.254.254 255.255.255.0
!
interface Ethernet1
nameif outside
security-level 0
ip address 192.200.200.1 255.255.255.0
!
interface Ethernet2
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet3
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet4
shutdown
no nameif
no security-level
no ip address
!
passwd 2KFQnbNIdI.2KYOU encrypted
ftp mode passive
access-list in_nameif_outside remark "This is acl going in to outside interface"
access-list in_nameif_outside extended permit icmp any any echo
access-list in_nameif_outside extended permit icmp any any echo-reply
access-list in_nameif_outside extended permit icmp any any time-exceeded
pager lines 24
logging enable
logging buffered informational
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
icmp permit any inside
icmp permit any outside
no asdm history enable
arp timeout 14400
global (outside) 1 interface
nat (inside) 1 192.168.254.0 255.255.255.0 tcp 4000 0
access-group in_nameif_outside in interface outside
route outside 192.100.100.0 255.255.255.0 192.200.200.2 1
route outside 192.168.100.0 255.255.255.0 192.200.200.2 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout uauth 0:05:00 absolute
dynamic-access-policy-record DfltAccessPolicy
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
no crypto isakmp nat-traversal
telnet timeout 5
ssh timeout 5
console timeout 0
threat-detection basic-threat
threat-detection statistics access-list
!
!
ssl encryption rc4-sha1
prompt hostname context
Cryptochecksum:162b16acec82534b3fab51c345340f06
: end
pixfirewall#
My PC loopback address is 192.168.254.1
I have an ip address outside which is 192.100.100.1
On my pc, I made a static route for the following address
route add 192.100.100.0 mask 255.255.255.0 192.168.254.254
and
route add 192.200.200.0 mask 255.255.255.0 192.168.254.254
This way, I can ping thus IP on GNS3 LAB
Pinging 192.200.200.2 with 32 bytes of data:
Reply from 192.200.200.2: bytes=32 time=11ms TTL=255
Reply from 192.200.200.2: bytes=32 time=10ms TTL=255
Reply from 192.200.200.2: bytes=32 time=10ms TTL=255
Reply from 192.200.200.2: bytes=32 time=10ms TTL=255
Ping statistics for 192.200.200.2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 10ms, Maximum = 11ms, Average = 10ms
and
Pinging 192.100.100.1 with 32 bytes of data:
Reply from 192.100.100.1: bytes=32 time=13ms TTL=255
Reply from 192.100.100.1: bytes=32 time=12ms TTL=255
Reply from 192.100.100.1: bytes=32 time=12ms TTL=255
Reply from 192.100.100.1: bytes=32 time=12ms TTL=255
Ping statistics for 192.100.100.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 12ms, Maximum = 13ms, Average = 12ms
and can even telnet on the router at LAB behind PIX with ip 192.100.100.1
more later...
